10/30/2022 0 Comments Atlauncher not launching instance![]()
Mojang Launcher: When using the Mojang launcher debug.log is found in. log is added the log will appear with the. #ATLAUNCHER NOT LAUNCHING INSTANCE WINDOWS#Windows hides file extensions by default so the installer may appear without the. This log will be called either installer.log or named the same as the installer but with. Post your installer log, found in the same place you ran the installer Stay Tuned with UnixArena.Please post logs using one of the following sites (Thank you Lumber Wizard for the list):ĭo NOT use sites like Mediafire, Dropbox, OneDrive, Google Drive, or a site that has a countdown before offering downloads. More interesting stuff to come about Openstack. If you want to access the instance through the key pair, please check it here. RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:72 errors:0 dropped:0 overruns:0 carrier:0 RX packets:114 errors:0 dropped:0 overruns:0 frame:0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 ssh password:Įth0 Link encap:Ethernet HWaddr FA:16:3E:A6:81:BE Here I am accessing the instance from control node. You should be able to access the instance within the private IP range (If you didn’t allocate the floating IP). (If console is not working due to above mentioned issue). You can also check the log to know the instance is booted or not. In Openstack’s kilo branch, console may not load properly if you didn’t add the below parameter in the nf file during the installation.Ĩ. You should be able to access the instance here as well by double clicking the console bar. If you would like to see the instance console, click the instance name and select the console tab. ![]() Using this IP, You should be able to access the instance.ħ. In the IP address tab, you can get the private IP address for the instance. Once the instance is completely up, you can see the screen like below. It will take few minutes to boot the instance depends on the image size which we have selected. Here you can see that instance has been launched. Click “Launch” to launch the new instance. Also select the security group which we have created. From the drop down box, select the key pair “UAPAIR” which we have created earlier. Click on Access & security tab for the instance.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |